12
12
Allegiant
®
Tow Discrete Light Bar
Federal Signal
www.fedsig.com
Setting the Light Bar Flash Pattern
Setting the Light Bar Flash Pattern
HEAVY OBJECT: Use lifting aids and proper lifting techniques when removing
or replacing this product. Failure to heed this warning may cause personal
injury.
Carefully unpack the light bar assembly and any other products included in the
shipment. Inspect them for damage that may have occurred during shipping. If a
product has been damaged, do not install or operate it. Immediately file a claim with
the carrier describing the damage.
Carefully check all envelopes, shipping labels, and tags before removing or
destroying them. If you are missing any parts, contact Customer Support at
1-800-264-3578, 7 am to 5 pm, Monday through Friday (CT).
Setting the Light Bar Flash Pattern
Although the Allegiant
®
light bar is configured and programmed at the factory, you
may want to change default settings and flash patterns before you install the light bar.
Before you begin, decide if you want to change these default settings:
Discrete Bars
MODE 1, 2
You can select a pattern for each mode from the light bar’s library of 28 patterns.
Making the Electrical Connections
To supply power to the light bar, use a fully charged 12-volt automotive battery.
Follow these steps:
1.
Place the light bar on a sturdy, flat surface.
2.
Attach the Black wire to the negative battery (–GND) terminal.
3.
Attach the Red and/or Yellow power line through a fuse rated in Tables 6 and 7
to the positive battery (+BAT) terminal. If a switch is desired, attach the switch
between the fuse and the battery.
Setting the Light Bar Flash Pattern
The light bar can change the flash pattern for Modes 1 and 2. To change the flash
pattern:
1.
Attach the Black wire to the negative battery (-GND) terminal.
2.
Apply +BAT to the Red and/or Yellow wire to turn on the light bar. If Mode 2 is
being changed, apply +BAT to the Brown wire as well.
3.
Quickly tap the Brown/White wire to +BAT three times.
