FDI ELI43-CR Quick Start Manual Download Page 2

Page: 2 / 2

ELI43-CR / ELI43-CP

Quick Start Guide

Page

06/05/2018

Revision 1.2

Apply Power to ELI with a 12VDC (+/- 5%) 2.0A power supply such as the Digi-key PN:

Mouser PN:

(See Figure below).

Rev ≥3.0: 5

-24VDC (+/- 5%)

Once you have verified or configured your SBC for the proper resolution, power on your SBC.

The ELI display will power on and show the output from the SBC.

Touch Screen Calibration should be performed in your operating system following one of the application
notes (Linux only) found here:

ELI43-CR / ELI43-CP Connections

Power may be supplied either via the 2.1mm power jack P2 (center positive) or via the

2-pin terminal block J8

For troubleshooting tips, please visit the FDI support website at:

We’d like your feedback and welcome constructive comments to:

Summary of Contents for ELI43-CR

Page 1: ...the table is not exhaustive ELI products are designed to work with any single board computer that has an HDMI or DVI output To submit a question about ELI s compatibility with a platform or operating...

Page 2: ...display will power on and show the output from the SBC 6 Touch Screen Calibration should be performed in your operating system following one of the application notes Linux only found here https www te...