4
3.0 CONNECTIONS, CONTROLS AND INDICATIONS
Rear Panel
Diagram I – Rear Panel
3.1
SENSOR CONNECTOR: Accepts the male LEMO plug from
the AX80 transducer.
3.2
TRANSDUCER (SENSOR) CABLE: The AX80 transducer is
provided with a rugged 10 ft. cable. This cable is mounted to
the transducer by means of a screw-on type connector. This
allows for replacement of the cable in case of damage to a
connector or the cable itself. Under typical day-to-day use, the
cable should remain attached to the transducer. The connector
assembly has been mounted to the transducer and packed with
a special purpose silicone grease to waterproof the sensor and
to prevent corrosion of the terminals.
Note:
WHENEVER
THE
CONNECTOR/CABLE
ASSEMBLY
IS
DISCONNECTED
FROM
THE
TRANSDUCER,
REPACK
THE
CONNECTOR
WITH
A
DAB
OF
G.E.
#661
SILICONE
GREASE.
DO
NOT
USE
ANY
OTHER
SUBSTANCE.
3.3
BACKLIGHT SWITCH: Controls the backlight mode of the unit.
To enable the meter backlight, press the switch into the “ON”
position. To turn the backlight off, select the “OFF” position.
3.4
HEADPHONE/CABLE JACK: Used to provide the audio output
to the operator. For survey, insert the headphone plug into the
jack to monitor the output.
