FBII OMNI-848, User Giude

Page: 11 / 28

- 11 -
Turning The System On
(cont)
TO TURN THE SYSTEM ON IN INSTANT MODE
In INSTANT mode, all alarm sensors including doors that normally have a
delay to allow you to turn the system off will report an alarm immediately if
activated. Check to make sure the system is ready. When it is ready, press:
INSTANT
followed by your user code.
When the system has been turned on successfully, the On/Off light and the
Instant light will be on, and the following will display:
LCD Keypad:
ON: INSTANT
PART 1
Fixed-Glass Keypad:
INSTANT
LED Keypad:
Arm and Instant LED lit
TO BYPASS A ZONE
The Bypass function excludes a zone of protection from the security system
until it is unbypassed (either by using the unbypass procedure or when you
turn the system off). Bypassing can only be done while the system is turned off.
Press the BYPASS button. Then enter your user code and the zone number
(1-7) to be bypassed, as follows:
BYPASS followed by your user code
†
+ ZONE #
†
If the Quick Bypass feature has been enabled by the installer, do not enter the
user code when bypassing zones.
NOTE: Bypassed zones are NOT protected when the system is turned on. After
the bypass command has been accepted, the keypad sounds one long beep, and
the following will display:
LCD Keypad:
BYPASSED: ZN 01
FRONT DOOR
Fixed-Glass Keypad:
BYPASS
zone number displayed
LED Keypad:
zone LEDs of the zone(s)
bypassed slowly blink
TO UNBYPASS A ZONE
Pressing the BYPASS button returns a bypassed zone to normal operation. To
unbypass a zone(s), repeat the bypass function as follows:
BYPASS followed by your user code
†
+ ZONE #.
After unbypassing, the zone display will show the state of the zones.
†
If the Quick Bypass feature has been enabled by the installer, do not enter the
user code when unbypassing zones.