- 20 -
FEDERAL COMMUNICATIONS COMMISSION (FCC)
STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for
use. The FCC requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer's instructions, may cause
interference to radio and television reception. It has been type-tested and found to
comply with the limits for a class B computing device in accordance with the
specifications in Subpart J Part 15 of FCC Rules, which are designed to provide
reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be
determined by turning the equipment on, the user is encouraged to try and correct the
interference by one or more of the following measures:
If using an indoor antenna, have a quality outdoor antenna installed.
Re-orient the receiving antenna until interference is reduced or eliminated.
Move the receiver away from any wire runs to the control/communicator.
Plug the control/communicator into a different outlet so that it and the receiver are on
different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions.
The user or installer may find the following booklet prepared by the Federal
Communications Commission helpful: "Interference Handbook." This booklet is
available from the U.S. Government Printing Office, Washington, DC 20402.
The user shall not make any changes or modifications to the equipment unless
authorized by the Installation Instructions or User Guide. Unauthorized changes or
modifications could void the user's authority to operate the equipment.
TELEPHONE OPERATIONAL PROBLEMS
In the event of telephone operational problems, disconnect the control by removing the
plug from the RJ31X wall jack. We recommend that your certified installer demonstrate
disconnecting the phones on installation of the system. Do not disconnect the phone
connection inside the control/communicator. Doing so will result in the loss of your
phone lines. If the regular phone works correctly after the control/communicator has
been disconnected from the phone lines, the control/communicator has a problem and
should be returned for repair. If upon disconnection of the control/communicator, there
is still a problem on the line, notify the telephone company that it has a problem and
request prompt repair service. The user may not under any circumstances (in or out of
warranty) attempt any service or repairs to the system. It must be returned to the
factory or an authorized service agency for all repairs.
This control unit was manufactured under rigid quality standards and
complies with all UL requirements for its intended use. Maintenance is best
performed by your installing company with trained service personnel.
