Fayat DYNAPAC SD2500C, Operating Instructions Manual

Page: 420 / 580

E 11 42
Mounting the sensor bracket
A
A sensing system with 3 sensors is pro-
vided over the entire length of the big ski.
One sensor each on the centre element,
and the front and rear end elements.
A
The centre sensor should be mounted
on the ski in precisely the location in
which it would be found during normal
operation (approx. the height of
the auger).
The two other sensors should be mount-
ed the same distance away from it.
A
Extendable sensor brackets (1) are
mounted in the two outer positions; the
normal sensor bracket (2) is mounted in
the centre.
- Place the sliding bracket (3) over the
corresponding big ski element from
the inner side.
- Insert the sensor bracket (4) into the
sliding bracket (5) from below and se-
cure with the relevant star
handle bolts.
- Place the clamping ring (6) onto the
sensor bracket tube and secure with
the relevant star handle bolt.
- In the case of the extendable sensor
brackets, slide in the arm extension
(7) and secure in position with the rel-
evant star handle bolt.
5
4
6
6
7
2
1
MBS2.bmp/MBS12.bmp