Fayat Group DYNAPAC F1800W, Operation & Maintenance Manual

Page: 89 / 330

D 12.18 7
Item Designation Brief description
14
Starter / drive
engine OFF
For starting and shutting off the drive engine.
- On actuation, the starter is in operation
- Switch the running engine OFF by pressing the
button again
m Run the starter continuously for a maximum
of 20 seconds, then take a break for 1 minute!
A
All emergency stop buttons (on the operating panel and
the remote controls) must be pulled out when starting.
15
/
16
Drive lever
(traction)
For switching on the paver finisher functions and for
continuously regulating the road speed – forward or reverse.
Centre position: Engine in neutral; no travel drive;
- To swivel the drive lever out, release by pulling the handle
(16) up.
Depending on the position of the drive lever, the following
functions can be activated:
1st position:
- Conveyor and auger on.
2nd position:
- Screed motion (tamper/vibration) on; travel drive on;
increase speed until the stop is reached.
A
Use the preselector to set the maximum speed.
f The vehicle speed cannot be reduced to "0" with the
preselector. The vehicle advances slightly with
deflected drive lever, even if the travel drive preselector
is set to zero!
A
If the engine is started with the drive lever pivoted out,
the travel drive is inhibited.
To start the travel drive, first the drive lever must be
returned to the centre position.
A
When changing over between forwards and reverse
travel, the drive lever must remain briefly in neutral.