Fayat Group DYNAPAC DRP70D, Operating Instruction

Page: 66 / 112

8.2.1.2 Closing the protection hood
To fasten the protection hood, use only the prescribed original
screws.
Always screw in and tighten all screws and their washers.
Protective equipment: n Working clothes
n Protective gloves
1. Loosen the screw (1) on both sides.
2. Close the protection hood.
3. Tighten the screw (1) on both sides.
4. Screw in screws (2) and washers on both sides and tighten
them.
8.2.2 Bleeding the fuel system
The fuel shut-off valve automatically interrupts the engine’s fuel
supply if the oil pressure is too low.
This makes it necessary to bleed the fuel system in the following
situations:
n After an engine shut-down due to an empty fuel tank.
n After filling the fuel tank for the first time.
n After using the crank handle without starting, e.g. when tem-
peratures are low.
n After several unsuccessful starting attempts.
n After replacing the fuel filter.
Fig. 54
Fig. 55
Maintenance – Preparations/concluding work
DRP70D 66