FAURE FDP7406PZ, User Manual

Page: 17 / 24

Problem Possible solution
Load is too small, increase the load or use the
Minuterie programme.
The cycle time is too long or unsatisfactory dry-
ing result.
1)
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 18°C to 25°C.
Set the Minuterie or the Très sec programme.
2)
The tumble dryer does not heat up. The laundry
inside is cold and wet.
The filter is clogged. The emergency heater shut-
down.
Clean the filter (see chapter CARE AND
CLEANING ).
Display shows 1 min or few minutes to the cycle
end for longer time. The laundry inside is cold
and wet.
The filter is clogged. The emergency heater shut-
down.
Clean the filter (see chapter CARE AND
CLEANING ).
The display shows Err. If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
The display shows an Error code (e.g. E51). Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
1) After maximum 6 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the appliance.
• The drum is dirty.
• Incorrect setting of the conductivity sensor
( See chapter " Settings - Adjustment of the
remaining laundry moisture degree " for better
setting).
• The airflow slots are clogged.
• Room temperature is too low or too high
( optimal room temperature 18°C to 25°C )
TECHNICAL DATA
Height x Width x Depth 850 x 596 x 555 mm (maximal 583 mm)
17