FATEK P5150NH Installation Manual Download Page 5

Page: 5 / 8

4. Unpacking the Unit

FATEK HMI x1

Hook and Screw x10

FATEK PLC

Connector x1

A4 Double-sided Installation Guide x1

Power Connector x1

Pluggable Terminal

Block x1

5. Installation Procedures



Push the HMI into the cutout until the

waterproof ring contacts the plate.



Insert a hook into each mounting hole

on the HMI, and then tighten the screws
evenly with a moderate torque.



Failure to tighten the screws may cause

the HMI to fall, malfunction or short-
circuit. Excessive tightening may cause
deformation. The necessary torque is
about 0.16N

Summary of Contents for P5150NH

Page 3: ...le HB1 PLC Connector COM3 COM4 Termination Switch HB1 PLC Screw Hole Power Connector COM3 COM4 Pluggable Terminal Block Mini USB Connector USB Connector Ethernet RJ45 Connector COM1 DB 9 Male Connector Micro SD Card Slot Audio Phone Jack W 365 mm H 292 mm D 54 7 mm ...

Page 5: ...stallation Procedures Push the HMI into the cutout until the waterproof ring contacts the plate Insert a hook into each mounting hole on the HMI and then tighten the screws evenly with a moderate torque Failure to tighten the screws may cause the HMI to fall malfunction or short circuit Excessive tightening may cause deformation The necessary torque is about 0 16N m ...

Page 7: ...ctor PIN COM1 RS 232 1 NC 1 2 RX 3 TX 4 NC 5 GND 6 NC 7 RTS 8 CTS 9 NC 1 NC No Connection Pluggable Terminal Block PIN COM3 RS 422 COM3 RS 485 COM4 RS 485 1 NC NC DATA 2 NC NC DATA 3 GND GND GND 4 RX NC NC 5 RX NC NC 6 TX DATA NC 7 TX DATA NC ...

Page 8: ...t use the FATEK PLC connector to connect the main unit and then insert into the HB1 connector hole on the back cover of the HMI to complete the connection 26FL NO 29 SEC 2 JUNGJENG E RD DANSHUEI DIST NEW TAIPEI CITY 25170 TAIWAN R O C TEL 886 2 2808 2192 FAX 886 2 2809 2618 E mail sales fatek com tech fatek com Website www fatek com AUTOMATION CORPORATION ...