8.2) Intel Pentium 4 - Socket 478
8.2.1)
Apply Thermal Grease
Clean off particles and residue from the top of the CPU then
spread a thin layer of the included Thermal Grease thoroughly
on top of the CPU.
CPU (IHS)
1) Bolt
2) Grip(L-Type)
8.2.3)
Install Grips and Bolts
Interlock the L-Type Grips with the Clip. Insert the
two Bolts into the Inner Holes of the Grips.
3) Inner Hole
8.2.4)
Install the FHS
Set the FHS at the center of the CPU. Screw the
Bolts in slightly, and then tighten each Bolt a few
turns at a time while alternating between the two
until the Grips are completely pressed against the
Clip Support.
1) Grip(L-Type)
2) Clip Support
for Socket 478
8.2.5)
Connect Power Cable
* Please refer to Section 9.
8.2.2)
Install Clip Supports for Socket 478
Install the Clip Supports for Socket 478 on both sides
of the Retention Guide as shown in the diagram.
1) Retention Guide
2) Clip Supports for Socket 478
