2) Clip Support
for Socket 775
8.1) Intel Pentium 4 - Socket 775
8.1.1)
Install the Clip Support for Socket 775
Align the Clip Support for Socket 775 and the Backplate for Socket 775 with the Mounting Holes on the
motherboard and fasten them together using the Clip Support Fixing Bolts. The Lever Slot on the Clip Support
should be properly oriented on the hinged side of the socket lever when installing.
* The Backplate Support is used for the convenience of installation. You can remove it if it is not necessary.
1) Clip Support Fixing Bolt
3) Motherboard
5) Backplate Support
6) Socket Lever Hinge
7) Lever Slot
8) Socket Lever
9) Lever Slot
2) Clip Support For Socket 775
4) Back Plate For Socket 775
8.1.2)
Apply Thermal Grease
Clean off particles and residue from the top of the CPU
then spread a generous amount of the included
Thermal Grease thoroughly on top of the CPU.
Note)
Unlike the flat-milled base of the FHS, the top surface of an LGA775 CPU may have minute dips and
peaks causing pockets of non-contact between the FHS and CPU. Please apply a generous amount of
Thermal Grease on the top of the CPU.
8.1.3)
Install Grips and Bolts
Interlock the S-Type Grips with the Clip. Insert the two
Bolts into the holes of the Grips.
1) Bolt
2) Grip(S-Type)
8.1.4)
Install the FHS
Set the FHS at the center of the CPU. Screw the Bolts
in slightly, then tighten each Bolt a few turns at a time
while alternating between the two until the Grips are
completely pressed against the Clip Support.
1) Grip(S-Type)
CPU (IHS)
8.1.5)
Connect Power Cable
* Please refer to Section 9.
