Fat Shark
6
RC Vision Systems
AV in/out Port
RCA Connector
: Yellow: Video, White: Audio Left,
Red: Audio Right
Recording Video
Connect AV cable to AV out port on right side of headset. Connect recording device to
cables and set up as per manufacturer directions.
Note: Cables pins are not all the same (see above chart), be sure to connect to headset
using the included cable.
Using an external receiver:
Use the AV cable to connect headset to the RCA AV port of
external devices.
To share the base station power supply with your goggles,
pick up a 3m Dominator AV cable accessory from your
retailer. Note; internal receiver must be shut off to properly
display external AV.
Battery Charging
The 7.4V lithium polymer battery pack is equipped with a 3 pole balance
charger lead that allows the battery to be charged off standard RC battery pack
chargers (not included). Follow your charger instructions for setting up for 1A 7.4V
Li-po. Some chargers require a discharge cable to be connected (not included – accessory).
Do not exceed 1A charging current.
Note (1)
: If the charger fails to announce charge complete, but is showing battery
voltage at 8.4V, the charge can be considered finished.
Note (2)
: If battery becomes fully discharged or accidentally shorted, an internal
safety circuit will trip. To reset the battery, tap 9V direct to the barrel connector via
the discharge adapter cable’s banana connector (black = GND, red = 9V). This will
instantly reset the battery and it can be recharged as normal.
Ground Video AudR AuL
