CPC314
C P C 3 1 4 U s e r M a n u a l
36
© 2 0 2 1 F a s t w e l V e r . 0 0 1
To receive a reset signal using the XP18 connector, feed the voltage to the XP18/1 and XP18/2
connector pins ranging from + 3 to 5.5 V.
To manufacture the cable, it is recommended to use a PHR-2 (JST) socket with SPH-002T-P0.5S
(JST) pins.
Table 1-23
– Purpose of GPIO (XP18) port pins
1.10.23 Port for External Battery Connection
To connect an external battery, you should use XP6 2-pin connector.
To manufacture the cable, it is recommended to use a PHR-2 (JST) socket with SPH-002T-P0.5S
(JST) pins. Voltage range: from +2.9 to 3.3 V.
Table 1-24
– Purpose of GPIO (XP6) port pins
1.11 Labelling
The consumer container used for storing the product is labelled by means of an individual identifier
(sticker).
The consumer container sticker contains the following information:
Product designation;
Device version;
Serial number of the device;
Manufacturer’s trademark;
Barcode.
* The location of the fields with product-related information may differ slightly from the one shown
in this figure.
RESET: B 2B-PH-KL (JST)
Pin
#
Function
Pin
#
Function
1
+V (+3...+5.5 V)
2
GND
3V BATTERY: B 2B-PH-KL (JST)
Pin
#
Function
Pin
#
Function
1
+3 V
2
GND
