8
www.fastTT.bike
FastTT Aero Bar Installation Guide – TT Bar
Placement options
FastTT aero bars offer a wide range of bolt holes
and bracket placement options for you to find your
preferred setup.
Fitting adjustable angled risers
If fitting FastTT adjustable angled risers, bolt the
bottom blocks of the risers to your base bar or
spacer stack. Tighten to maximum 6Nm.
Add the top block to the bottom block and
insert the M6 locking bolt. Adjust to your
preferred angle and tighten the bolt to a
maximum torque of 12-13Nm.
Insert two 10mm bolts into the
slots in the top side of the
mounting bracket. Only button
head bolts can be used. If you
replace them with hex cap screws
the bracket WILL NOT sit flush
with the bar base.
NOTE:
The 4x 16mm bolts should NOT be used for mounting the TT bars. These are only used
for FastTT Tri bars.
SECTION C – MOUNTING THE BARS
