6
2.5 Dip Switch Setting
Termination and Master/Slave: Set the switches according to your configuration.
ON
1 2 3 4 5 6 7 8
S1
Figure 4 – DIP switches setting
2.6 Quick Installation Procedure
The dome camera must be installed by qualified service personnel in accordance with all local
and federal electrical and building codes.
1. Fasten the J-box to a rigid wall using the supplied screws.
2. Connect the control signal wires between the dome and J-Box.
3. Connect the 12 VDC power to the J-box.
4. Connect the supplied shielded 8-pin cable between the data1 port of the KBD and the
data1 port of J-box. When you connect the dome camera to the data2 port of J-Box,
you should connect unshielded 8-pin cable between the data2 port of the KBD and the
data2 port of J-box.
5. Connect the BNC cable from the Aux of appropriate switching device to J-box if
needed.
6. Turn on the KBD power after all dome cameras have initialized.
7. The keyboard controller will search for all the attached dome cameras and then show
the ID of dome cameras found.
8. The user will be prompted for a password for authorization. The user must enter a 4-
digit PIN code. There are two authorization levels: operation only and programming.
The factory default passwords are 1111 for user, 9999 for administrator.
9. Move the joystick to control the camera direction (Pan, Tilt), and rotate the handle to
the counterclockwise/ clockwise for zoom Out/In. Depending on the amount of rotation
or deflection of the joystick, zoom and pan/tilt speed will be change.
NO
SETTING
DISCRIPTION
On
1
Off
DOME1 Port Termination
On
2
Off
Mux/Slave Termination
On
3
Off
DOME2 Port Termination
4~6 -
Reserved
On Slave
7
Off Master
On PAL
8
Off NTST
