Fastjet F500 Series, Operation Manual

Page: 12 / 52

2.6.3 PRINT SET
1. Used to enable or disable the printing function. if set to "Disable", the printer will
disable the printing function and prompt "High voltage not activated" in the status bar.
2. It is used to select the printing quality, standard and high quality 01~15. The higher the
high quality selection, the better the printing quality will be, but the slower the printing
speed will be.
3. It is used to set whether the main screen “F1 Manual Start/Stop Printing” is e ff ective. If
you need to use an external sensor such as an electric eye, you need to set this option
to “Disable ”.
4. Photocell 1 Set, refer to 2.6.8 Photocell 1 setting submenu.
5. Photocell 2 Set, refer to 2.6.9 Photocell 2 setting submenu.
6. Set the encoder mode, you can set "internal", "external". When set to "External", it is
e ff ective to use an encoder.
7. Used to reset the counter used in the current message to any value within the counter
range.
8. The product counter on the main screen can be reset to any value.
9. It is used to set the printing mode of the printer, which can be set to “Single”, “Repeat”,
“Continuous” and “Traverse”.
10. When the print mode is set to “Continuous”, use this menu to set “Internal
Interval” (valid when the shaft encoder is internal), “External Interval” (valid when the
shaft encoder is external) and “Measure” related options.
11. When the print mode is set to “Repeat ”, use this menu to set the “Print times” to
control the print times per trigger.
12. When the print mode is set to “Traverse”, use this menu to set the options for traverse
printing;
13. It is used to set the ratio between the actual e ff ective value and the set value of the
message width, delay and message interval. Default value is 1.
Page 8