9WMV/V + Series User’s Manual
3-17
both support Ultra DMA/33, select Auto to enable BIOS support.
The Choice: Auto, Disabled.
USB Controller
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller
and you have USB peripherals.
The choice: Enabled, Disabled.
USB Keyboard Support
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller
and you have a USB keyboard.
The choice: Enabled, Disabled.
Init Display First
This item allows you to decide to active whether PCI Slot or on-chip VGA first
The choice: PCI Slot, Onboard .
AC97 Audio/Modem
This item allows you to decide to enable/disable the 810 chipset family to support
AC97 Audio/Modem.
The choice: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block read/writes
per sector the drive can support.
The choice: Enabled, Disabled
POWER ON Function
This item is used to select Wake on Keyboard/Mouse mode.
Any Key: This function allows you wake up the system by clicking any key.
Button Only: Disable Wake on KB/MS function. You can boot up your
system by power button only.
9WMV/V + Series User’s Manual
3-18
Keyboard 98: If selecting this option, you can boot up the system by power button
and the wake? Key on Keyboard 98 .
Password: Disable the function of power button and let the system can only be
powered on through the preset keys (like a password).
Hot Key: If selecting this option, you also need to specify the hot key from
Keyboard Power On item.
Mouse Left: This function allows you wake up the system by clicking left mouse
button twice successively.
Mouse Right: This function allows you wake up the system by clicking right mouse
button twice successively.
The Choice: Keyboard 98,Password,Hot KEY, Mouse Move, Mouse Click,
Any KEY, BUTTON ONLY.
KB Power ON Password
You can specify 1-5 keys as a password
.
The choice: Enter
Hot Key Power ON
If you select Hot Key option in power On Function Item, you need to specify a hot
key here.
The Choice:Ctrl-F1—Ctrl-F12
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has
no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item is configurable only if the "Onboard UART 2" is enabled. This allows you
to specify the mode of serial port 2.
ASKIR - Select this setting if you installed an Infrared module via IrDA connector
(refer to section 2.3 "Connectors"). This ASKIR setting allows infrared
serial communication at a maximum baud rate of 56K baud.
HPSIR - Select this setting if you installed an Infrared module in your system via
IrDA connector (refer to section 2.3 "Connectors"). The HPSIR setting
