9WMV/V + Series User’s Manual
2-11
9.Primary/Secondary IDE Connectors
The motherboard supports up to four IDE devices, including CD-ROM drives, tape
backup drives, Hard Disk Drives, and other IDE devices. After connecting the
single end to the board, connect the two plugs at the other end to your hard
disk(s). If you install two hard disks, you must configure the second drive to Slave
mode by setting its jumper accordingly. Please refer to your hard disk
documentation for the jumper settings. (Pin 20 is removed to prevent the users
inserting the IDE devices in the wrong orientation when using ribbon cables with
pin 20 plugged).
Note: Ultra DMA/66 IDE devices must use an 80-wire IDE cable or else devices
will automatically be limited to Ultra DMA/33 mode.
10.Floppy Disk Drive Connector:
You can attach up to two floppy drives to the motherboard. After connecting the
single end to the board, connect the two plugs on the other end to the floppy
drives. The drive A: should be connected on the end and the drive B: in the
middle.
Note: Pin 5 is removed to prevent the users inserting the Floppy Disk Drive in the
wrong orientation when using ribbon cables with pin 5 plugged.
Primary/Secondary IDE Connectors
Primary IDE Connectors
Color : Blue
Secondary IDE Connectors
Color : White
PIN1
PIN1
NOTE: Orient the red markings on the floppy ribbon cable to
pin 1
Floppy Disk Drive Connector
Floppy Disk Drive Connector Color : White
PIN1
NOTE:
Orient the red markings on the floppy ribbon cable to pin 1
9WMV/V + Series User’s Manual
2-12
11.Wake-On-LAN(WOL)/Wake-On-Modem(WOM) connectors
The Wake-On-LAN and Wake-On-Modem connectors connect to a LAN card and
Modem card respectively with a Wake-On-LAN/Wake-On-Modem output. The
connectors power up the system when a wakeup packet or signal is received
through the LAN card/Modem card.
12.Serial Port COM2 Pin Header:
The provided serial port bracket can be used to add an additional serial port for
additional serial devices.
Note: Pin 10 is removed to prevent the users inserting in the wrong orientation
when using ribbon cables with pin 10 plugged.
Wake-On-LAN(WOL) connectors
PIN
FUNCTION
1
+5V_SB
2
GND
3
SIGNAL
NOTE : The ATX power supply supports larger than 720mA
5V Standby current.
Serial Port COM2 Pin Header
B TYPE
PIN FUNCTION PIN FUNCTION
1
DCD
6
DSR
2
RXD
7
RTS
3
TXD
8
CTS
4
DTR
9
RI
5
GND
10
N.C
