21
3SLAV2 User’s Manual
System Panel Connectors (J3)
Refer to the following figure for item 11 to 15.
11.Power LED Lead
This indicates the status of the system power is turned "ON' or "OFF" The
LED will light when the system power is turned on and will go off when the
system power is turned off.
12.System Warning Speaker Connector
This 4-pin connector connects to the case-mounted speaker.
13.ATX Power Switch Lead
The system power is controlled by a momentary switch connected to this
lead. Pressing the button once will switch the system between ON and
SOFT OFF. Pushing the switch while in the ON mode for more than 4 sec-
onds will turn the system off. The Power LED shows the status of the sys-
tem power.
14.HDD LED Lead
This connector supplies power to the cabinet IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE con-
nectors will cause the LED to Light up.
15.Reset Switch Lead
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch. This is a pre-
ferred method of rebooting to extend the life of the system power supply.
+
+
+
+
Summary of Contents for 3SLAV2
Page 8: ...8 3SLAV2 User s Manual 1 3 Block Diagram...
Page 59: ...59 3SLAV2 User s Manual...
Page 64: ...64 3SLAV2 User s Manual...
