REBUILD/REPAIR INSTRUCTIONS
Page 8 of 9
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
www.fastestinc.com
WP172 Rev A 08/2/2021
31. Rotate this assembly so sleeve end is on flat surface.
32. Make sure collets/jaws stay inside the sleeve.
33. Install retaining ring into groove on body.
34. Install second actuator/magnet and spring components into hole on backside of
the housing.
35. Slide the ICON module along the flat on housing.
36. ICON module will be used to compress and contain the magnet spring into place.
37. Install the screws through module and into the housing.
38. Verify that the assembly is operating properly by actuating the connector several
times with test piece connection.
39. Connector the media supply back into the termination port and connect the Sure
Seal cable back into the M8 termination.
40. If connector ICON needs to be reprogrammed see instruction WP168.
OPEN END OF
ACTUATOR
HOLE IN
HOUSING
MAGNET SPRING
FLAT ON
HOUSING
