3
Part #170450
Revised 3/08/07
FAST™
3400 Democrat Rd.
Memphis, TN 38118
Phone: (901) 260-3278 Fax: (901) 375-3408
www.fuelairspark.com
shop can install the threaded bushing for you. It is still advisable to locate where you would like
the sensor mounted, mark it, then let the shop drill the hole and weld the bushing in place.
2.
Run sensor cable to interior of vehicle.
Attach the cable’s sensor connector to the oxygen
sensor and then route the cable to the interior of the vehicle.
3.
Connect cable to power and display.
Plug in the cigarette lighter power adaptor and connect
it to the sensor cable. Plug in the sensor cable to the side of the display housing. The unit
should automatically power-up at this point.
4.
Follow the on-screen menu options.
Select the sensor options, wait for the unit to warm-up,
and then read your air/fuel ratio. There are several sensor options to choose from. Single sensor
mode will measure only one sensor. Dual sensor mode will measure two sensors. In dual sensor
mode you can read these sensors individually (Fig. A) or as a combined average.
Operational Features & Descriptions
Data Logging
:
1.
In any live air/fuel display screen, you may press the up-arrow button (the button next to the L
on the display screen) to begin recording your air/fuel ratio (Fig. A). When pressed, the L will
begin to flash, indicating that you are now recording. The FAST™ Air/Fuel Meter contains
enough memory to record up to 50 minutes of data in single sensor mode and up to 25 minutes
in the dual sensor mode. When you are finished recording, simply press the up-arrow button
(L) again. The L will stop flashing and your data log is saved. If you press the up-arrow button
(L) again, the old log is erased and a new log will be created.
Fig. B
Analog Signal Output
Wire (GREY)
Signal Ground Wire
(BLACK)
Fig. A
The “up-arrow” button next to the “L” starts
the data logger recording the air/fuel data
The “down-arrow” button next to the “P”
starts the data logger playback mode
