Fast MT765 Challenger, Installation-Parts

Page: 9 / 31

INSTALLATION & PARTS
Track Tank MT765 Challenger Page 9
INSTALLATION
Remove Step Assembly
WARNING: Step assembly weighs
approximately 300 lbs. Use an
appropriate lifting device to
prevent injury.
1. Loosen the four bolts (1) holding the
step assembly to the support tube.
2. Attach a lifting device to the step
assembly.
3. Remove the step assembly.
4. Remove the four bolts (2) and lower
step tube (3). Discard the tube and its
hardware.
Install Receiver Mounting
Brackets
WARNING: Mounting bracket
weighs approximately 75 lbs. Use
an appropriate lifting device to
prevent injury.
1. Install the left-side mounting bracket
(1) on the tractor with 3/4” x 2” GR8
bolts (2) and flange nuts. Refer to the
torque charts in this Manual for bolt
torque values.
2. Repeat Step 1 with the right-side
mounting bracket (3).