Fasep 2000 srl
Rev. 1.2
Balatron 331.G3: User
’s Manual
May 31, 2013
2-1
2
INSTALLATION
2.1
Moving the unit
I
WARNING
When the unit has to be moved: never lift balancer
by motor shaft or by neighborhood of it.
2.2
Assembling the unit
For ease of transportation, the wheel balancer might be disassembled into
units. If necessary, assembling instruction are provided within each
package.
2.3
Installation
The wheel balancer must be installed on a firm and level ground.
G
NOTE
:
the machine must be secured to the floor. Using four
holes in the base and anchor bolts provided.
2.4
Electrical Hookup
!
CAUTION:
Failure to follow these instructions can results in
damage to unit or create an electrical hazard and
will void warranty.
2.4.1
Electrical hookup is to be provided by a qualified electrician.
2.4.2
A fusible wall-mounted switchbox is required at the installation site. This
switch should provide on-off control and overload protection for your
wheel balancer only. The switchbox should be fused with time-delay
fuse(s) in accordance with the power rating specified on your wheel
balancer.
2.4.3
Electrical connection of the machine should be by plug connectors.
2.4.4
The balancer must be effectively connected to ground. The electric cord
is regularly provided with a ground terminal.
2.4.5
Make sure that Power Rate Specifications for your wheel balancer (refer
to nameplate on the wheel balancer) comply with those provided by the
external power source.
!
CAUTION
After electrical hookup has been performed unit is ready to operate. Always observe pertinent safety
precautions when operating the unit (see Appendix tables for an overview of relevant Safety
requirement).
Summary of Contents for BALATRON 331.G3
Page 35: ......
