4
FRONT PANEL CONTROL
1. Firmware Reset:
push a small paper clip into
this opening to reset the unit’s CPU.
Note:
Use this reset only if the unit will not
respond to commands. It will not erase
custom settings. Use the Factory Restore
command in the Setup Menu to completely
reset firmware. See the setup section of the
manual for details.
2. Power/Standby:
Press to turn the unit On
(LED turns Green) or to Standby (Red).
3. Infrared Receiver Window
4. LCD Readout:
Provides information on control
of the processor. Displays current Function
being used, matching the On-Screen-Display.
When in the Setup Menu, the OSD is not
available, use the LCD display.
SYSTEM FIRMWARE SETUP
Now that all the sources and cables are connected,
the processor’s firmware needs to be setup for the
installation.
Be sure to go through the Setup menu
before doing the final setup of the display.
When the unit is first plugged in it will go through an
initializing procedure and display the output
resolution. Do not send any commands to the unit
during this initialization period. Once this initialization
is completed the unit is instant-on.
Note:
All display devices have specific setup steps
that must be completed to insure proper
operation with the NRS-DVI and other
sources. Be sure to carefully follow those
instructions as well as the instructions for
this processor.
To enter the Setup menu, press and hold the Menu
button on the remote for five seconds.
Setup Functions can only be viewed on the front
panel LCD, not from the OSD.
Press the Function Up or Down to select the available
Functions. Press the Value Up or Down keys to
change values or to select options.
SETUP MENU FUNCTIONS
Set: Active Output
Analog/Digital (Default)
This must be selected to determine if the Analog
(BNC) or Digital (DVI) output is used.
Both outputs
cannot be used at the same time.
Output Format
(Analog)
RGB (Default) /YPrPb
Note: Selecting RGB means connecting the
processor to the display via five wire analog RGBHV.
This function is not active when DVI output is
selected. DVI is always RGBHV.
Composite Sync on H
On/Off (Default)
Note: this function is not active when YPrPb output
is selected
Sync on Green
On/Off (Default)
Note: this function is not active when DVI output is
selected. It is automatically set to On when YPrPb
output is selected.
Horizontal Sync Polarity
Negative (Default) / Positive
Changes sync polarity, which may be needed for
compatibility with some displays.
Vertical Sync Polarity
Negative (Default) / Positive
Changes sync polarity, which may be needed for
compatibility with some displays
SETUP
1 2
3
4
