12
SET: STORE PAL PROFILE
STORE PROFILE 1-8
Stores all current settings for PAL sources (30
different parameters) to the preset number
selected. See STORE NTSC for more details.
• The processor auto-detects the input refresh
rate (60Hz/50Hz) and recalls Profiles stored for
that rate. 60Hz Profiles cannot be recalled while
viewing 50Hz sources and vice-versa.
SET: RESTORE FACTORY
PRESS STORE
Resets processor firmware to original factory
levels.
• Only use this command if processor completely
locks up and other troubleshooting steps do not
solve the problem.
• Before using this option, try first unplugging
unit from power (or push a paper clip into the
small opening on the front panel). This will
often clear software lockups, and does not
erase settings.
DVP1080MF oPeratIon
Each time the processor is powered up, it will
go through an initialising power-up sequence.
FRONT PANEL CONTROLS
(see illustration opposite)
RESET:
In the event of a processor firmware
lockup, insert a small paper clip into opening
to reset. Stored profiles and system settings
will not be erased.
• Unplugging the unit from its power source will
accomplish the same task.
POWER:
Press to turn ON unit (LED Green),
press again to put unit in STANDBY (LED Red)
• All settings are stored in nonvolatile memory so
a power loss will not result in loss of settings.
IR WINDOW:
Location of IR sensor for remote
control and IR remote systems
VFD (VACUUM FLUORESCENT DISPLAY):
Provides information on the status of the
processor. The readout will match what is
being controlled via the OSD. It also provides
readout of the SETUP menu functions and unit
warnings.
• The SETUP menu is only visible via the front-
panel VFD
ON-SCREEN DISPLAY (OSD)
There are four OSD menu pages: INPUT,
PICTURE, DISPLAY, PATTERNS.
I
NPUT
: INPUT, ASPECT RATIO, PROFILES
PICTURE
: BRIGHTNESS, CONTRAST, COLOR, TINT,
DETAIL, ADVANCED COLOR CONTROL
DISPLAY
: IMAGE POSITION, IMAGE BLANKING
PATTERNS
: TEST PATTERN ON/OFF, SELECT
The remote control is used to access these
menus.