23
Revision date: 09.25.18
115277
7
Cut and Install 1/4" Nutrient Supply Tubes
Complete these steps:
1. Using the 109170 tube cutter, cut a section of 111046 (1/4") micro tubing
(not to exceed 20")
to
determine how long you want each 1/4" supply tube to be.
ATTENTION:
Use photos and diagram to decide where you want micro valve positioned in each
supply tube for a uniform look. Location of micro valve in each supply tube should allow easy
access to operate valve once installed.
2. Cut tube from Step 1 into two pieces—length may differ depending on valve position—and add
111047 micro valve. Check the fit on the system by holding the tube next to where it will be
installed.
3. Adjust tube length and valve position as needed and create the remaining tube and valve
assemblies by using the first one as the template.
4. Install each tube by sliding one end onto one 109242 adapter and inserting the remaining free
end into the drilled hole of the 111030 end cap directly above that adapter. Wet the adapter and
tube for easier installation.
CUT AND INSTALL THE 1/4" MICRO TUBES
