GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
18
113836_37_38_39 Revision date: 06.06.18
24. Using end frame diagram, determine the number of
remaining vertical end frame supports. Place one band
clamp on end rafter for each.
25. Using end frame diagrams (Quick Start section), mark
locations of the remaining vertical end wall supports on
the base tube.
26. Choose tubes for each remaining vertical support.
27. Use the steps presented earlier in these instructions
and the end frame diagrams to measure and cut each
section of square tubing for the remaining vertical
frame members.
INSTALL THE END WALL FRAME (continued)
Front (or outside)
of the greenhouse
Square-to-
Round Tube
Connect
Bracket
Band
Clamp
Position all screws, bolts
and clamps so they will
not damage the end wall
panels when panels
are attached to the
end wall frame.
End Rafter
30. Align center of frame member with center mark on base
tube and attach top of frame member to band clamp on
rafter. Do not tighten.
31. Verify that frame member is plumb and use FA4482B
Tek screws to secure 104624 fitting to base tube and
frame member.
32. Tighten band clamp and
install an FA4482B short Tek
screw through clamp and into rafter.
33. Repeat as needed to assemble and install remaining
vertical end wall supports.
34. Return to each frame member and install an FA4482B
Tek screw through the backside of each tube fitting to
secure end frame support to tube fitting.
35. Return to each band clamp, 104624 connector, and
square tube splice and verify that a Tek screw is
installed. Install an FA4482B Tek screw if needed.
Inside view
of end rafter
ATTENTION:
Remember to subtract the amount
needed to account for the square-to-round tube
connect bracket that will be attached to the top of each
remaining frame member.
28. Choose a square-to-round tube connect bracket and
attach bracket to one end of vertical frame member.
Use a 5/16" drill bit to drill a hole through tube and
attach bracket to tube using a nut and bolt.
29. Slide a 104624 1-way connector onto the frame tube
and set assembly on base tube of end frame.
Center Mark
FA4482B
Tek Screw
FAH320 Bolt &
FALB32B Nut
