23
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 06.20.18
END PANEL INSTALLATION (continued)
10. Install end cap profile on bottom of small panel.
When
installed, it will overlap top of door frame.
11. Using Tek screws (no washers), secure panel in place
above door by installing a screw through center of
H-channel and into frame member.
NOTE:
H-channel must remain below top of rafter
and short enough to allow for installation of final piece
of aluminum profile. If necessary, remove panel, cut
H-channel, and reinstall panel.
12. Cut and prepare a panel (as previously described) to
cover remaining area along door. (Use the remainder of
4' x 12' panel from Panel A.)
End Cap
104548
H-channel: Install
flat side out.
Trimmed polycarbonate panel
above the door.
9. Measure between
edges of H-channel
at panel bottom
and cut a section of end cap profile (104548) to fit
between H-channel.
Trimmed
4' x 12' Panel
Not to scale.
B
B
A
14. Continue installing polycarbonate panels and aluminum
profile in locations shown on end panel diagrams
(Quick Start section) for front and back end walls.
Diagram shows end panel locations. Consult End Panel
Diagrams when installing panels.
6' x 10'
Panels
13. Place panel in position with its UV-protected surface to
the outside and attach to end wall framing.
