9
Revision date: 02.17.16
115106S Screen Installation for 24" x 24" Kit
Required parts:
• Panels from previous page.
• 102198 Spring Wire
Complete the steps that follow to install insect screen.
See right column of prevous page for 115106S panel
preparation steps. After preparing panels, continue
with the steps below.
For kits 115107S and 115108S, skip to page 10 or 11
(depending on kit) and continue.
Exercise caution when cutting and installing spring
wire. Wear eye protection during installation and
when handling spring wire to prevent injury.
INSTALL INSECT SCREEN
1. Secure Panel 1 to upper channel along one side.
Pull tight toward bottom of frame square and secure
in side and bottom channels. Pull panel under frame
toward remaining open side. Secure to bottom
channels in the same manner. Finally, pull panel to
upper channel along opposite side and secure.
2. Cut spring wire to length as needed. Do not stretch
screen too tight. View sample photos on page 7.
3. Trim panel as desired. Leave 2" or more to reattach
and stretch panel if needed.
5. After securing panel to top square of
frame, stretch panel down to cover
front and secure in same channel used
for Panel 1 by installing another run of
spring wire.
6. Trim excess panel. Leave 2" or more to
reattach and stretch panel if needed.
4. Install Panel 2 as shown above.
ATTENTION: Install spring wire and
panel
in same channels used for Panel
1 installation where panels overlap
.
Secure Panel 1 in upper
channel here first.
Secure Panel 2 in upper channel
against building here first.
Secure Panel 2 in lower front channel
last. Channel is located on underside.
Panel 1
Panel 2
Secure Panel 1 in
this upper channel
last.
Secure screen to
bottom u-channel
(underside of frame).
TOP
FRONT
