7
WEATHERSHIELD CANOPIES
Revision date: 10.10.08
Leg
131P068
Pipe Identification
Location
Pipe
Length
Leg
131P068
68"
INSTALL LEGS
This section describes attaching the legs to the roof frame.
See illustration below to identify main parts of the frame.
1. Using the leg pipes, insert the legs into the 3-way and
4-way couplers of the main frame.
Do not install the
main frame legs during a storm or windy day
.
2. Secure each pipe in the coupler using the locking
eyebolt. If the couplers are not equipped with locking
eyebolts, secure each pipe in the coupler using a Tek
screw.
ATTENTION
: If used, position Tek screws so they
will
not
touch the main cover when installed.
3. Inspect the frame for sharp edges or Tek screws that
could damage the covers. Reinstall the Tek screws if
necessary (or rotate the pipes) and remove or tape any
sharp edges.
4. After the entire frame is assembled, verify that each
locking eyebolt is tight.
5. Set the frame in the desired location and measure
diagonally from corner-to-corner to square the frame.
The diagonal measurements will be identical when the
frame is square.
6. Properly anchor the assembled frame as described in
the MUST READ document included with the shipment.
NOTE:
DO NOT install the cover without anchoring the
frame.
7. After anchoring the frame, continue with attaching the
main cover.
