9
CANOPIES
Revision date: 03.01.23
SQUARE THE ASSEMBLED FRAME
Gather the parts:
• Measuring tape and assistants
Complete these steps:
1.
With the frame in position, perform a final square of the
frame by measuring diagonally (corner-to-corner) as
shown below at the bottom of the legs. Verify that the
two measurements are equal and adjust if needed.
2. Measure width from center of rafter leg to center of
other rafter leg of the same rafter assembly. Adjust if
needed. Repeat for all rafter assemblies.
FRAME TOP VIEW
3. Examine the frame and remove any sharp edges from
the frame or reposition screws (if equipped) so they do
not come in contact with the roof cover.
4. After the frame is squared, read or reread the MUST
READ document and anchor the shelter.
FRAME ASSEMBLY (CONTINUED)
4. Add horizontal struts (#QH1308) between rafter pipes
at each rafter. Secure at each end using a band clamp
as shown below.
5. While lifting one side of the assembled roof structure,
insert a 77″ pipe into the 3-way and 4-way couplers
then tighten eye bolts. Refer to the illustration below.
6. Repeat step for the other side of the frame.
7. Verify that all eye bolts are tight and square the frame.
