![background image](http://html.mh-extra.com/html/farmtek/104299/104299_manual_545435009.webp)
9
CHICK-INN
Revision date: 12.19.07
Lower Leg Assembly
Gather the parts:
• Lower leg pipes 24'' (#131P024)
With the roof frame assembled, connect the 24" lower leg
pipes to the assembly as instructed below:
1. Lift one side of the assembled frame and slide the 24"
lower leg pipe into the 3-Way and 4-Way couplers.
2. Secure the leg pipes in the couplers as needed using
the locking eye bolts.
3. Repeat steps to install the leg pipes for the remaining
side of the assembly.
4. Verify that all eye bolts are tight and square the frame.
RAFTER ASSEMBLY (CONTINUED)
SQUARE THE ASSEMBLED FRAME
Gather the parts:
• Measuring tape
Complete these steps:
1.
With the frame in position, perform a final square of the
frame by measuring diagonally (corner-to-corner shown
below) at the bottom of the legs and verify that the two
measurements are equal. Adjust if needed.
2. Adjust width. Measure width from center of rafter leg to
center of other rafter leg of the same rafter assembly.
Adjust if needed. Repeat for all rafter assemblies.
3. Examine the frame and remove any sharp edges from
the frame, or reposition screws (if equipped) so they do
not come in contact with the roof cover.
4. After the frame is squared, read or reread the MUST
READ document and anchor the shelter.
24''
FRAME TOP VIEW
MUST BE
EQUAL WIDTHS
24” Leg Pipe