Manual
VIDIUM P 350 | P 450
20
│
24
5.3.8
Setting the Disk Coulter
The depth of the disk coulter is set in the following way: loosen the
screw S and set the arms of the balance lever A according to the
required working depth so that the head does not rub against the
ground. When setting the arms of the balance lever A, it is required to
make sure that the teeth fit together and that the screw
S
is tightened
accordingly.
The side distance of the disk coulter from the plough body should be about
1 to 3 cm and it should stick out above the ploughshare of the fertilizer
back-filler. This distance may be set by turning the head of the disk coulter
C. The head can be turned after the belt D is loosened. To loosen and
tighten the belt, use the tension of the bolt that is far from the head of the
disk coulter C (greater grip).
The side deflection of the coulter is set by stopper B. The disk coulters are
mounted to holder H according to the distance in the forward direction
when there is a larger quantity of residues during harvest.
5.3.9
Fertilizer Back-filler
The fertilizer back-fillers are set so that the working depth is about 1/3 of the depth of ploughing. They can be
set deeper when there is a larger quantity of residues during harvest. If the fertilizer back-filler is disruptive when there
is a larger quantity of residues after harvest, it can be easily removed by loosening two bolts.
It is not recommended to use the back-filler in rocky oils (there is not protection against rocks).
6.
MAINTENANCE AND REPAIRS OF THE MACHINE
Observe the safety instructions for maintenance and treatment.
If you have to use welding during a repair and have the machine connected to the tractor, make sure that all
supply cables are disconnected from the alternator and accumulator.
Check that all screws and other assembly points are tight before each use of the machine and whenever
needed.
Regularly check the wear and tear of the working parts of the machine or replace the worn working parts
with new ones.
Adjusting, cleaning and lubricating the machine may only be performed when the machine is standing still
(the machine is stopped and is not working).
Immediately remove any plant and other residues collected on the bearing shaft, otherwise the bearing will
get damaged.
When lubricating bearings, be cautious not to damage them.
When the machine is lifted, use an appropriate supporting device propped at designated places or at
appropriate places.
When adjusting, cleaning, maintaining and repairing the machine, secure those parts of the machine that
could put the operator in danger by fall or other movement.
For attaching the machine when manipulating it with the use of lifting equipment, use only places marked
by stick-on labels with the symbol of a chain „
“.
If there is a defect or damage on the machine, immediately turn off the tractor engine and secure the engine
from turning on, secure the machine against movement
then you can remove the defect.
When repairing the machine, use only original spare parts, suitable tools and protective equipment.
Keep the machine clean.
When lowering the machine down, be cautious not to drop it on the reinforced surface as it could damage
the chisels and ploughshares.
Do not use a high-pressure cleaner or direct water jet for cleaning hydraulic rollers and bearings. The
bearings and seals are not waterproof under high pressure.
