Manual
TURBULENT 3 | TURBULENT 5 | TURBULENT 6
14
│
27
Bring the machine into the transport position.
The operator is obliged to pay increased attention during transport on roads, due to the transport
dimensions of the machine.
The operator must observe the valid regulations for transport on roads (laws, decrees) after connecting the
machine to the tractor, for reason of a change of the axle load. The driving properties of the set also
change depending on the terrain nature, adapt the manner of driving to these conditions.
The operator is obliged to present the machine certificate of roadworthiness as needed, according to the
valid regulations for road traffic (decree, law) (only in the Czech Republic).
The operator is obliged to secure sufficient outlook during reversing from his position of the tractor
driver. In case of insufficient outlook, the operator is obliged to call a competent and informed person.
The operator must fold the side frames for transport and secure then against unwanted unfolding by
disconnecting the hydraulic circuit of the machine and the tractor.
The operator must secure the arms of the rear TPS of the tractor in the transport position during road
transport, i.e. prevent unexpected arm drop using the hydraulic arm control lever. At the same time, the
arms of the rear TPS of the tractor must be secured against side swinging.
During machine transport on roads, the operator must observe the valid laws and decrees that deal with
this topic and which specify the relationships of the tractor axle load depending on transport speed.
5.
MACHINE WORKING BODY ADJUSTMENT
Fig. 7 – Machine working body adjustment
The range of the working depths of the machine is stated in the following table.
Machine processing depth setting point
Scale 1-10
Disc depth setting point
Perform the depth setting identically on the left and the right side of the machine.
For access to the depth setting places use only antiskid steps.
Do not step on any other part of the machine, especially on the tyres, under any circumstances – there is a
risk of injury.
Table of orientation depth of the
Turbulent 3-6 machine
Machine
depth
setting
Orientation depth
(mm)
1
35
2
70
3
105
4
140
5
175
6
210
7
245
8
280
9
315
10
350
Tow bar
Angle discs
Copying wheels
Spring securing
Rear tyre rollers
