34
│ 53
Manual
TRITON HEAVY 660 PS
SETTING THE WORKING DEPTH OF THE CHISELS
▪
The working depth of the chisels is set by adjusting the machine frame height above the ground.
▪
In the front of the machine, the depth is set using the height of the tractor hitch above ground.
▪
In the rear of the machine, the depth is set on the supporting roller.
▪
The machine frame must always be parallel to the ground in order to ensure proper soil cultivation.
▪
Setting is done by changing the number of spacers or clips on the piston-rods.
▪
The table states the individual working positions and the number of space washers needed to achieve
the required machine depth.
▪
The stated working depths of the individual positions are for information only. They might differ
according to the individual soil conditions. It is possible to add or remove a required number of space
washers as needed
.
▪
The working depth of the machine must be set so that the spring protection of the working tools (tines)
does not unlock frequently. The spring protection should only
release very sporadically. Unlocking can
occur on a maximum of one working tool (tine) on the entire
machine after a 100 - 200 m drive. If
unlocking is more frequent, it is necessary to reduce the working depth or use narrow chisels. Due to
the frequent release of the spring protection, excessive wear of the pins and other parts of the spring
protection can occur. In this case, their more frequent replacement is necessary.
The number of the space washers must be the same on all piston-rods
!!!
