Manual
KOMPAKTOMAT K300P | K400PS | K450PS
30
│
44
7.4.1
MCD - MECHANICAL DEPTH SETTING
Standardly, the depth is set mechanically by turning the handle manually. Each working section of the
machine is controlled individually.
Machine
Number section (pc)
K300P
1
K400PS, K450PS
2
The depth setting is increased by turning the handle anticlockwise – red arrows in the picture.
The depth setting is decreased by turning the handle clockwise – white arrows in the picture.
There is an indicator near the handle that shows that all the sections are set at the same depth.
7.4.2
HD - HYDRAULIC DEPTH SETTING
Optionally, it is possible to set the share depth using an independent hydraulic circuit from the driver’s
position. Marking of the independent hydraulic circuit (p. 18), required parameters for the hydraulic
circuit (p. 5).
There are indicators located in spots visible from the tractor that show that all the sections are set at the
same depth.
The distribution of the hydraulic circuit includes elements providing even movement of all levelling bars.
Therefore, do not limit the oil flow on the control panel of the circuit. The flow rate values should range
between 75 and 100% capacity.
Without the manufacturer´s prior consent, do not interfere with the hydraulic circuit components in any
way!
7.5
ADJUSTING THE LEVELLER HEIGHT BEHIND SHARES
Perform the adjustment of the levellers when the machine is unfolded in the working position and
standing still.
The machine must rest on the working sections.
When adjusting the position of the levellers, always observe generally valid labour safety regulations.
The leveller behind the shares is used for even spreading of the loosened soil behind the rear row of
sweeps in front of the rear roller.
Correct position of the leveller affects the resulting quality of processing.
The position of the leveller is secured by inserting a chain loop into the hole on the supporting frame.
The chain is secured by inserting a companion part and a safety pin.
