Farmet DUOLENT DX 380 NS, Operating Manual

Page: 20 / 38

COMMISSIONING
8.1 Agregation to a tractor
• The machine can be connected only to a tractor, whose curb weight is identical or higher than
the overall weight of the connected machine.
• The machine operator must observe all generally valid regulations of work safety, health
protection, fire safety, and environmental protection.
• The operator may connect the machine exclusively to a tractor that is equipped with a rear
three-point suspension and a functional undamaged hydraulic system.
• The table of requirements for the towing means for work with the machine:
Requirement for the tractor engine power for cultivator DX 380 NS 120-210 kW* (161-282 HP)*
Requirement for
the tractor's TPS
Spacing of the lower
suspension joints (measured
at the joint axes) TPS 2
870+/- 1,5 mm (34,25 in)
TPS 3
1010+/- 1,5 mm (39,76 in)
ø of the hole of the lower
suspension joints for the
machine suspension pivots TPS 2 28,7 – 29,03 mm (1,13 – 1,14 in)
TPS 3
37,4 - 37,75 mm (1,472 – 1,486
in)
ø of the hole of the upper
suspension joint for the
machine suspension pivot TPS 2
25,7 – 25,91 mm (1,012 – 1,020
in)
TPS 3
32,0 – 32,25 mm (1,260 – 1,270
in)
Requirement for the tractor engine power for cultivator DX 460 NS 150-270 kW* (201-362 HP)*
Requirement for the tractor engine power for cultivator DX 550 NS 180-320 kW* (241-429 HP)*
Požadavek na
TBZ traktoru
Spacing of the lower
suspension joints (measured
at the joint axes)
TPS 3
895±1,5 mm (35,24 in)
KIROVEC
1110±1,5 mm (43,7 in)
ø of the hole of the lower
suspension joints for the
machine suspension pivots
TPS 3
37,4 – 37,75 mm (1,472 – 1,486
in)
KIROVEC
60,5 – 61 mm (2,381 – 2,401 in)
ø of the hole of the upper
suspension joint for the
machine suspension pivot
TPS 3
32,0 – 32,25 mm (1,260 – 1,270
in)
KIROVEC 39,5 – 40 mm (1,555 – 1,574 in)
Requirement for
the tractor's
hydraulic system
Side frame folding circuit
Circuit pressure 200bar (2900
Psi), 2 pcs of quick-coupler
sockets ISO 12,5
* Recommended towing means, the real towing force may significantly vary according to the processing
depth, soil conditions, land slope, working body wear and adjustment.
• Connect the machine using the TPS suspension bar to the lower arms of the rear TPS of the
tractor, secure the TPS arms using pins against disconnecting.
• Connect the third point of the tractor only to the circular hole both for work and transport.
(concerns machine DX 380 NS).
• The machine aggregated with the tractor changes the distribution of the weight to the
individual axles of the tractor. The weight of the front axle is reduced and therefore the
controllability gets worse. It also affects braking properties.
When connecting, no persons may stay in the space between the tractor and the machine.
20 | 38