Farmers Friend Pyroweeder, Assembly And Instruction Manual

Page: 6 / 13

8 9
Well-designed, quality tools and equipment | farmers friend llc .com (931) 583-0397 | support@farmersfriendllc.com
S T E P 3
Tool Bar and Handle Assembly
PARTS NEEDED
•
1 × Handle Assembly (from Step 2)
•
1 × Tool Bar
•
4 × 1⁄4 "-20, 1" Carriage Bolts
•
4 × 1⁄4 " Washers
•
2 × 1⁄4 "-20 Locknuts
•
2 × 1⁄4 "-20 Nuts
1.
Attach the Tool Bar and Handle Assembly
as shown below.
2.
Tighten the locknut far enough so that the
handle tie is lightly pressing against the
End Plate of the Tool Bar , but not so tight
that the handle can not swivel.
3.
Repeat this step on the opposite side of
the
Tool Bar .
S T E P 4
Tool Cart
PARTS NEEDED
•
1 × Tool Bar and Handle Assembly
(from Step 3)
•
2 × Wheels
1.
Remove the 5⁄8 " locknut and one washer
from the axle bolt.
2.
Mount the wheel onto the axle bolt and
replace the washer and locknut as shown.
3.
Tighten the locknut just enough so that
the washers are lightly pressed against
the wheel. Do not over tighten.
4.
Repeat this step on the opposite side of
the
Tool Bar .
Handle Assembly
Tool Bar and Handle Assembly
Wheel
5⁄8 " Washer
5⁄8 " Locknut
1⁄4 " Washer
1⁄4 "-20 Nut
End Plate
1⁄4 "-20 Locknut
1⁄4 "-20, 1" Carriage Bolt
Angled Handle Tie
Tool Bar