Maintenance
1.
Sprinkler clogging: In the case of sprinkler clogging, turn off
your water supply and do one of the following:
A.
For
Senninger Wobblers
, unscrew and remove sprinkler
head. Use a paper clip or other small wire to push down
through the top of the nozzle hole. Bang the sprinkler
head on your hand to dislodge any foreign objects.
B.
For
Netafim Meganets
, hold base of sprinkler and
unscrew the top. There is a plastic filter cage inside the
sprinkler. Remove the filter cage and rinse under clean
water. Reassemble.
2.
Moving sprinkler setup: When you first try to move the
sprinkler stands, you may find that the sprinkler tubes will not
easily pull out of the grommets. You may need to use a pair
of pliers to hold onto the grommet while you twist the tubing
out. With repeated use, this problem usually takes care of
itself, but remember not to be overzealous in pushing the
tubing into the grommet.
(931) 583-0397
(931) 583-0397 | [email protected]
15
6.
Flush the line by turning on your water supply and running
the water until it comes out the end of the polyethylene
tubing.
7.
After flushing, attach the Flush Valve to the end of the
polyethylene tubing.
8.
Push the sprinkler stakes into the ground by each of the
brown grommets and then insert the sprinkler tube into
the brown grommet. Don’t push too hard—it is a friction fit.
If you ordered the Meganet Road Guards, you can snap
them on the first and last Meganet sprinklers.
Step 5
Step 8
maintenance 1a
maintenance 1b
maintenance 1b
