Well-designed, quality tools and equipment
Well-designed, quality tools and equipment
|
| farmersfriend.com
farmersfriend.com
14
1.
First, build the sprinkler assemblies.
A.
Attach the Stake Adapter to a stake by putting the
stake on a hard surface and using a hammer to tap
the adapter on.
Note:
You can tell if the adapter is
fully seated by looking in the little “window” under the
adapter head. The stake should fully fill the window.
B.
Next, screw the Sprinkler Head onto the sprinkler
stand. Hand tighten.
C.
Finally, snap the sprinkler stand onto the stake
adapter—making sure to line up the angles on the
stand and adapter.
2.
Lay the Polyethylene Tubing down the center of your field
block.
Note:
The sprinklers effectively cover eight 30" beds
with 12-18" pathways. So, you would want to run the tubing
between the fourth and fifth beds.
3.
Using an 8mm Flat Tube Punch, make holes in the
polyethylene tubing. If you are using 4 sprinklers/row, you
will want to punch the holes at approximately 12' 6", 37' 6",
62' 6", and 87' 6". If you are using 5 sprinklers/row, you will
punch the holes at approximately 0' (as close to the supply
line as possible), 25', 50', 75' and then as close to the end
as possible.
(
Note:
In the case of a misplaced hole, while punching the
black tubing with the flat tube punch, we have provided
goof plugs
. To insert, push the small end of the goof plug
into the hole until you hear a “pop”.)
4.
Push a Brown Grommet into each punched hole.
5.
Attach the Hose Adapter to the supply end of your poly-
ethylene tubing and hook up to your water supply.
Assembly
Instructions
Step 1a
Step 1b
Step 1c
Step 3
Step 4
