Farm King Allied 8420G, Operator And Parts Manual

Page: 49 / 80

Maintenance - 7420, 8420, 8420G
45
Safety Sign (Decal) Installation
IMPORTANT
When replacing safety signs (decals), the
temperature must be above 10° C (50° F).
• Remove all portions of the damaged safety sign
(decal).
• Thoroughly clean the area with adhesive remover
and glass cleaner. Remove all adhesive residue.
• Allow the area to dry completely before installing the
new safety sign (decal).
• Position the safety sign (decal) in the correct location.
• Remove a small portion of the backing paper on the
safety sign (decal).
• Press on the safety sign (decal) where the backing
paper has been removed.
• Slowly remove the remaining backing paper,
pressing on the safety sign (decal) as the backing
paper is removed.
• Using the backing paper, pressing firmly, move the
backing paper over the entire safety sign (decal) area.
Note: Small air pockets can be pierced with a pin
and smoothed out using the piece of the
backing paper.
Storage And Return To Service
Storage
Sometimes it may be necessary to store your Farm
King snowblower for an extended period of time.
Below is a list of items to perform before storage.
IMPORTANT
DO NOT permit children to play on or around
the stored machine.
• Thoroughly wash the machine with a pressure
washer or water hose to remove all dirt, mud, debris
or residue.
• Lubricate all bushings to remove any water residue
from washing.
• Remove any material that has become entangled
around any moving part.
• Place hydraulic hoses or electrical connector (if
applicable) in the storage brackets.
• Inspect the hitch and all welds on the equipment for
wear and damage.
• Check for loose hardware, missing guards, or
damaged parts.
• Check for damaged or missing safety signs (decals).
Replace if necessary.
• Replace worn or damaged parts.
• Touch up all paint nicks and scratches to prevent
rusting.
• Place the equipment in a dry protected shelter.
Note: If a dry protected shelter is not available,
cover with a waterproof tarp and tie down
securely.
• Place the equipment flat on the ground.
• Support the jack / frame with planks if required.