Farm King 480, Operator And Parts Manual, Page: 10 / 32

10
8. Mount two B-164 belts (#54) on the outside ring welded to the front drum ring and the 3"
pulley at the back of the reducer shaft. Assemble the two idler arms (#71) and the 4-5/8" o.d.
idler pulleys (#73) on the idler arm shaft welded to the front frame as shown in drawing. Use a
5/8" x 4" hex bolt (#87) and lock nut. A flat washer is placed on each side and between the idler
pulleys. A bushing (#72) slides on the shaft between the idler arms and is held on by a 1/4"
cotter pin. The two tightener springs hook into the 5/16" hole at the top corner of the idler and
into the top edge of the right hand side frame.
If the cleaner is purchased with a trash pan, the next step should be to assemble the pulleys
and idler for the trash pan. These instructions follow the instructions for the basic cleaner.
When all pulleys have been mounted, bolt the pulley guard (#74) to the front frame and hitch
using 5/16" x 3/4" hex bolts, lock washers and hex nuts. Bolt the intake pan (#75) to the top of
the front frame using 3/8" x 1" hex bolts, lock washers and hex nuts. See page 16 for drawing.
9. Fasten the discharge pan (#91) to the rear frame using four 1/4" x 3/4" self tapping screws and
two 5/16" x 3/4" hex bolts, lock washers and hex nuts. Bolt the bottom trash chute mounting
bracket (#93) to the rear frame using 5/16" x 3/4" hex bolts, lock washers and hex nuts. The
bracket must be turned as shown in drawing. See page 16 for drawing.
10. Mount the three cone screen sections (#49) on the cone frame inside the drum. Pin all three
sections to the cone at the ends and joints using 1/4" x 3/4" self tapping screws and flat
washers, and then strap the ends and center using straps (#45, #46, & #47). Tighten straps
with 1/4" x 2-1/2" round head bolts and hex nuts. After strapping, all the remaining self tapping
screws are inserted in the cone. Assemble the three pieces of the drum around the outer drum.
A convenient way to hold the screen in position during assembly is by hooking several small
springs across the lap joint. Two springs to hold the screen in place (#152) are included in the
bag with each cleaner.
Be sure the screens are flat against the
drum rings before fastening with 1/4" x
3/4" self tapping screws and flat washers
around the edges and joints. Straps (#44)
are placed around the screen at each drum
ring and tightened using 1/4" x 2-1/2"
round head bolts and 1/4" hex nuts. After
strapping, the remaining self tapping
screws are inserted in the drum. See page
17 for drawing.
11. After the drum screens are in place, the
rear drum shield (#132) is mounted to the
rear frame using six 1/4" x 3/4" self tapping
screws and two 3/8" x 1" hex bolts, flat
washers and hex nuts. Join the discharge
pan (#91) and the rear drum shield (#132)
where they overlap at the ends using four
1/4" x 3/4" hex bolts, lock washers and hex
nuts. See page 16 for drawing.
Assembly - 480 Grain Cleaner
CAUTION
All the strap bolts holding the drum screens should be turned so
the end of the bolt trails the direction of rotation as shown in the
drawing. This is done so the end of the bolt will not accidentally
hook onto your hand or clothing while the drum is rotating.
Back
Front
Direction of
Rotation
End of Bolt
Trails Rotation