Farm King 1460, Operator And Parts Manual

Page: 39 / 168

Assembly - Fertilizer Applicator 1460
39
Twin Piston Pump
Figure 20
Cut the zip tie (Item 1) [Figure 20] holding the suction
hose to the toolbar and route it to the right and over the
top of the assembly and pump mount.
Figure 21
Remove the tape from the hose and loosen the 11/32” t-
bolt clamp with a 3/8” wrench. Insert the hose into the 2”
hose barb (Item 1)
[Figure 21] attached to the bottom
side of the pump assembly.
Slide the clamp over the hose and barb. Tighten until
secure.
Installing Monitor Hose
Figure 22
Cut the zip tie holding the hose to the monitor and route
the hose (Item 1)
[Figure 22] between the frame
assembly and the parallel links.
Remove the tape from the hose and loosen the 1-3/4”
stainless clamp with a standard screwdriver.
Insert the hose into the 1 1/2” hose barb attached to the
top side of the pump assembly. Slide the clamp over the
hose and barb. Tighten until secure
[Figure 22] .
B-11047
1
B-11050
1
B-11048
1