Farm King 1370, Operator And Parts Manual

Page: 58 / 146

Maintenance - 1370, 1385, 1395, 13114 Backsaver Auger
56
Winch Will Not Raise Or Lower
Check that the circuit breaker (Item 1) is not
deactivated. Push the button in to reset. This could
be caused by defective motors or pinched wiring
[Figure 51] .
Check wiring for damage. Repair or replace
damaged wiring.
Check that the winch motor is operating properly.
Replace non-operational motor.
Winch Will Only Rotate In One Direction
Disconnect the control box from the winch. Use a
volts ohm meter to check the voltage at the winch
output connection.
There should be system voltage when pressing
the lift / lower button on the control box. If there
is voltage in both directions, the motor may be at
fault and will need to be replaced.
If there is voltage in only one direction but not in
the other, this is most likely a control relay failure
(Item 2)
[Figure 51] .
Use the wire colors to determine the relay at fault:
• Yellow wire leads to the winch-lower relay
• Brown wire leads to the winch-raise relay
Replace defective relay.
Remote Control Functions Correctly But The
Raise/Lower Switches On The Box Do Not
Check the wires leading to the move-raise and
move-lower switches (Item 3). Make sure the wires
are connected properly
[Figure 51] .
Check wiring for damage. Repair or replace
damaged wiring.
Figure 51
3
2
1