Farm King 1266, Operator And Parts Manual

Page: 13 / 32

13
Assembly - 1266, 1272, 1276 & 1282 Conventional Auger
CAUTION
When cycling the raising mechanism the first time, stop lifting
after the extending member has moved approximately one foot.
Then lower to be sure extending member will retract. If it will not
retract, investigate for problems.
11. Attach stop flags (Ref. #123 and #124) to the stop flag weldment (Ref. #120) using the 1/4" x 2"
cotter keys (Ref. #125) with the lettering facing up and toward the discharge end of the auger.
12. See separate assembly instructions for the different drive packages.
ALERT
Do not operate the auger empty during the break-in period.
For the best results, do not full feed the intake for the first 500
bushels. After break-in, never run auger at slow idle when full
feeding the auger. The worm winch should be greased annually.
Five grease zerks are located on the winch.
Assembly Instructions - 540 RPM PTO Drive
1. Attach the implement input driveline (IID) (Ref. #82) to the gearbox with 3/8" x 2" key (Ref. #82)
and 1/4" x 2-1/4" spiral pin (Ref. #82).
2. Mount the gearbox shield (Ref. #78) using 5/8" x 1" bolt and lockwasher (Ref. #77).
NOTE: Use a 3/8" x 1-1/4" Grade 5 shear bolt. Using other than a Grade 2 bolt may result in
damage to drive components.
NOTE: 540 RPM drive cannot be converted to electric drive without changing gearbox.
Gearbox is shipped dry from the factory.
Add No. 90 gear lube until 1/2 full.