70
71
VIII. ASSEMBLY INSTRUCTIONS
VIII. ASSEMBLY INSTRUCTIONS
1. Locate and remove all packaging from the fork. Locate and detach the
front fender from the rear fender.
2. When installing the front fender: push the fender against the fork crown
before bolting on the crown fender bracket. Doing so both holds the
headlight cable securely in the steerer tube, and ensures maximum tire
clearance (Figure E.2).
3. Route the motor cable on the outside of the fender strut. Secure the fender
struts to the fork dropouts and tighten the locknuts to their specified
torque.
4. Install the front wheel (See
To Install Your Front Wheel
on p.37) (Figures
E.3 & E.4). Double-check that the alignment washer on the rotor side of the
wheel is oriented correctly and the motor cable is connected, and routed
around the outside of the fender strut (Figures E.5-E.8).
5. Spin the front wheel to confirm that it is properly secured, and the fender
is not obstructing movement. Check that the fender line is evenly spaced
over the wheel.
F. INSTALLING THE PEDALS
1. Locate the pedals, pedal washers, and pedal reflectors, and remove any
remaining packaging from the bike.
2. Install the pedal reflectors onto the pedals.
3. Thread the pedals onto the cranks. The left pedal attaches to the non-
driveside crank arm, and right pedal attaches to the driveside crank arm; the
left pedal is reversed threaded. Tighten them both to the specified torque.
PRO TIP:
Always use pedal washers between the pedals and cranks. The
aluminum crankset is delicate and can be damaged easily.
G. ADJUSTING AND FINE-TUNING YOUR FARADAY:
E.5
E.6
E.7
E.8
F.1
F.2
G.1
G.2