ENGLISH
ENGLISH
GB-49
GB-48
Electrical Requirements
Please look at the rating label to know the
rating voltage and connect the dishwasher to
the appropriate power supply. Use the required
fuse 10 amp, time delay fuse or circuit breaker
recommended and provide separate circuit
serving only this appliance.
Electrical Connection
Insure proper ground exists before use
Ensure the voltage and frequency of the power
being corresponds to those on the rating plate.
Only insert the plug into an electrical socket
which is earthed properly. If the electrical socket
to which the appliance must be connected is
not appropriate for the plug, replace the socket,
rather than using an adaptors or the like as they
could cause overheating and burns.
Water Connection
Cold Water Connection
Connect the cold water supply
hose to a threaded 3/4(inch)
connector and make sure that
it is fastened tightly in place.
If the water pipes are new
or have not been used for an
extended period of time, let
the water run to make sure
that the water is clear. This
precaution is needed to avoid
the risk of the water inlet to
be blocked and damage the
appliance.
WARNING!
Please close the hydrant after using.
Drain hose Connection
Insert the drain hose into a drain pipe with
a minimum diameter of 40mm, or let it run
into the sink, making sure to avoid bending or
crimping it. The top of the hose must be less
than 1000mm.
