ENGLISH
ENGLISH
GB-21
GB-20
As the rinse aid diminishes, the size of the black dot on
the rinse aid level indicator changes, as illustrated below.
Full
¾ full
½ full
¼ full – should refill to
eliminate spotting
Empty
C (Rinse-Aid
indicator)
1. To open the dispenser, turn the cap a
quarter-turn to the left towards the central
indicator and lift off.
2. Pour the rinse aid into the dispenser, taking
care not to overfill it.
3. Close the cap by inserting it in line with the
central indicator and turning to the right.
NOTE:
Clean up any rinse aid spilled while
during filling with an absorbent cloth to avoid
excessive foaming during the next wash. Don’t
forget to replace the cap before you close
dishwasher door.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser
has six or four settings.
Always start with the
dispenser set on “4”. If
spots and poor drying
are a problem, increase the amount of rinse aid
dispensed by removing the dispenser lid and
rotating the dial to “5”. If the dishes still are not
drying properly or are show spots, adjust the
dial to the next higher lever until your dishes
are spot-free. The recommended setting is “4”.
(Factory value is “4”.)
NOTE:
Increase the dose if there are drops of water or
lime spots on the dishes after washing. Reduce
it if there are sticky whitish stains on your dishes
or a bluish film on glassware or knife blades.
D. Function of Detergent
Detergents with its chemical ingredients
are necessary to remove dirt, crush dirt and
transport it out of the dishwasher. Most of the
commercial quality detergents are suitable for
this purpose.
Adjust lever
(Rinse)
