Far Tools 118005, Manual, Page: 28 / 104

EN
INSTRUCTIONS FOR USE
PREPARATION FOR COMMISSIONING (BEFORE START-UP)
FUEL
Make sure there is sufficient fuel in the tank.
Only use a 2-stroke mixture as fuel. Unleaded petrol mixed with 2-stroke oil according a
ratio of 50:1 (2%).
Total tank capacity: 4 l.
Fuel mixing procedure
1-
Prepare the quantity of petrol that you want to add and pour it into the fuel tank
.
2-
Then use the fuel tank cap to measure the specified quantity of oil. Add it into the
fuel tank
3-
Shake the fuel tank to mix the oil and the tank, before starting the motor.
Pre-operation checks should be made each time the generator is used. The
engine and mufler will be very hot after the engine has been run. Avoid touching
the engine and muffler while are still hot with any part of your body or clothing
during inspection or repair.
!
If you do not use oil, the motor will overheat.
-Petrol is a highly flammable and toxic substance.
-Do not fill over the top of the fuel filter, to prevent the fuel from overflowing
when it heats up and expands.
-
Wipe any drips of fuel immediately
.
-after refueling, make sure the tank cap is tightened securely.
!
© FAR GROUP EUROPE
groupe electrogène 118005.indd 28 20/02/06 16:16:24